Step 9 Connect power cord

1

2

3

4

This section describes how to connect the power cord. HP recommends connecting the power cord to a surge protector.

To connect the power cord

1 Locate the power switch on the front of the printer. Make sure the printer is turned off (out position).

Note

If the printer is located on top of the 2,000-sheet feeder, do not connect the printer power cord to the convenience receptacle on this device. This connector is designed to connect to the paper output devices with the HP LaserJet 9000 series.

2 Connect the power cord to the printer, a grounded power strip, or an AC outlet.

3 Press the power switch to turn the printer on (in position). After the printer warms up, the READY message should appear on the control panel display.

4 If you have the optional 3,000-sheet stapler/stacker (or stacker), optional Tray 4, or both installed, check that the light on them is solid green. If the light is amber, flashing, or off, see the HP LaserJet 9000 Use manual (supplemental user guide) that can be downloaded from www.hp.com/support/lj9000.

ENWW

Connect power cord 19