Connecting an HP Remote 2C and HP Internet Router Module To a 100VG Network
If you have the following topology:
To A 100VG Network
Back of Remote 2C
HP Internet Router Module (in either slot of the Remote 2C)
In the above topology, HP does not recommend configuring the HP Internet Router Module for bridging. Instead configure the router to route IP, IPX, and Appletalk protocols. This is because bridging forwards multicast and broadcast packets from the 100 Mbit/s network to the much slower T1 or ISDN lines. This will overload the WAN link with traffic. In routing mode, the Router will not forward multicast and broadcast packets off of the network.
Connecting Power using an RPS or AC Power
1.(Optional.) This product is supported by the HP J2962A Redundant Power Supply (RPS). If you have this HP RPS, connect the RPS to the Remote 2C now.
Back of
Remote 2C
Back of RPS
(continued on next page)
9
