Description of LEDs on the Remote 2C
The Remote 2C has the following LEDs:
LED | State | Meaning |
|
|
|
|
|
Power | ON | The Remote 2C is receiving power. |
|
(green) | OFF | The Remote 2C is not receiving power. |
|
|
| ||
|
|
|
|
Global Fault | ON | One or both slot modules experienced a hardware problem. |
|
(orange) |
|
|
|
|
|
|
|
RPS | OFF | The Remote 2C is not receiving power from the HP J2962A Redundant Power Supply (RPS) | . |
(green) | ON | The Remote 2C is receiving power from the connected RPS. |
|
|
| ||
| Flashing | An error has occurred on the RPS connected to the Remote 2C. See the documentation |
|
|
| provided with the RPS for troubleshooting. |
|
|
|
|
|
ON | The corresponding module is connected to a |
| |
(green) |
| network. |
|
100VG | ON | The corresponding module is connected to a 100VG network. |
|
(green) | OFF | The port is not connected to any network or no slot module is present. |
|
|
| ||
|
|
|
|
In Use | ON | The module is inserted in the slot correctly. |
|
(green) | OFF | A module is not inserted in the slot or is inserted incorrectly. |
|
|
| ||
|
|
|
|
Act(ivity) | Flickering | Shows the amount of activity for the network connected to a port. |
|
(green) |
|
|
|
|
|
|
|
Link OK | On | The LAN connected to the |
|
(green) |
| successful (100VG). |
|
| Off | Link beat is not detected. |
|
| Flashing | The port is partitioned because of excessive collisions. |
|
|
|
|
|
Slot Specific |
| See the manual for that module for LED behavior. |
|
LEDs (4) |
|
|
|
|
|
|
|
Slot Fault | On | This module has experienced a failure. See Troubleshooting on page 13. |
|
(orange) | Off | The normal state. Indicates that there are no fault conditions on the module. Refer to the |
|
|
| ||
|
| four slot specific LEDs for more troubleshooting information. |
|
|
|
|
|
11
