HP AdvStack Remote 2C & Internet Bundle After Self Test:, During Self Test:

2.If you are not using an RPS, plug the included power cord into the Remote 2C’s power cord receptacle and into an AC power source as shown below.

Power receptacle on the back of the Remote 2C

3.After power has been applied to the Remote 2C, it executes a self test. Check the LEDs during self test. Self test lasts up to 3 seconds for the Remote 2C and then each module executes its own self test simultaneously. The self test time for each module varies depending on which modules are installed. The Internet Router Module requires approximately 60 seconds. If both modules are installed, self test time is still approximately 60 seconds because the modules self- test simultaneously:

During Self Test:

All LEDs are ON for the Remote 2C. Then some of the Remote 2C’s LEDs turn off while the modules are tested.

After Self Test:

LEDs For:	LEDs that are ON
Front of Remote 2C	Power
	RPS (if connected)
	In Use for Slot A and/or Slot B
	10Base-T or 100VG
Internet Router Module	Power
	Sys Ok
	LAN 10Base-T
	100VG
	Link OK
Internet Router Module	LAN Activity
Slide-In Label

10