HP Cell Phone storage works modular smart array 20 manual UID Circuit Board, VRM Power Supply

Removing and Replacing Components

UID Circuit Board

1.Disconnect the ribbon cable from the UID circuit board.

2.Remove the two screws (1).

3.Remove the UID LED and button panel (2).

NOTE: Take care that the plastic window does not fall out of the panel and get lost.

4. Tilt the edge of the board upward, and pull the board out of the chassis (3).

To install a UID circuit board, reverse this procedure.

VRM Power Supply

1.Pull out the latches on both sides of the socket (1).

2.Pull the VRM power supply straight out of the socket (2).

To install a VRM power supply, reverse this procedure. If the latches do not click into place, press them in manually to secure the VRM power supply module in the socket.

3-10 HP StorageWorks Modular Smart Array 20 Maintenance and Service Guide