HP COMBI 2180206H manual T00284

Combi HP thermostatic mixer shower

FITTINGitting theTHEfixedFIXEDheadHEAD- Built-in

(Built in option only)

The outlet pipe should protrude from the surface of the wall between 50 mm and 65 mm

(fig.65).

Mark four fixing hole positions by using the fixed arm as a template. Drill and plug the wall using the plugs supplied. Care must be taken not to drill into the buried pipework.

Remove burrs on the pipework to prevent damage to the ‘O’ ring.

Slide the special lock washer over the pipe and push it tight to the wall.

Note: Make sure the lock washer is placed on the pipe correctly with the inscription ‘FRONT’ facing away from the wall. This washer holds the pipe in position.

Slide the bushing over the pipe and push it tight against the wall.

Slide the ‘O’ ring onto the pipe up against the bushing.

Push the fixed arm assembly onto the pipe tight to the wall. An automatic watertight seal is thus created.

Secure to the wall with the four fixing screws supplied. Push-fit the trim into place (fig.66).

Finally, screw on the adjustable showerhead making sure the sealing washer is in place (fig.67). Screw on tight to make sure of a watertight connection.

Turn on the water supplies.

Fig.65

50 mm – 65 mm

Outlet pipe

T00284

Fig.66

	50 mm – 65 mm
		Trim
Fixed arm	'O' ring

	Special lock washer
T00285	Bushing

Fig.67

Washer

T00286

23