●USB board (see USB board on page 67)

●Power connector cable (see Power connector cable on page 69) To remove the display assembly in its entirety:

1.Disconnect the display panel cable (1) from the system board.

2.Release the wireless antenna cables from the clips (2) built into the base enclosure.

NOTE: Models may have either one or two antennas installed.

CAUTION: Support the display assembly when removing the following screws. Failure to support the display assembly can result in damage to the display assembly and other computer components.

3.Remove the five Phillips PM2.5×6.0 screws (1) that secure the display assembly to the computer.

72 Chapter 4 Removal and replacement procedures