g.Base enclosure (see Base enclosure on page 43)
h.System board (see System board on page 53) Remove the heat sink:
1.Following the 1, 2, 3, 4 sequence stamped into the heat sink, loosen the four captive Philllips screws (1) that secure the heat sink to the system board.
2.Remove the heat sink (2).
NOTE: Due to the adhesive quality of the thermal material located between the heat sink and the system board components, it may be necessary to move the heat sink from side to side to detach it.
NOTE: The thermal material must be thoroughly cleaned from the surfaces of the heat sink and the system board components each time the heat sink is removed. Replacement thermal material is included with the heat sink, processor, and system board spare part kits.
Thermal paste is used on the processor (1) and the heat sink section (2) that services it.
Component replacement procedures | 57 |