Table
Nonsystem disk/NTLDR missing message.
Cause | Solution | |
|
| |
The system is trying to start from a diskette that is not bootable. | Remove the diskette from the diskette drive. | |
|
| |
The system is trying to start from the hard drive but the hard | 1. Insert a bootable diskette into the diskette drive and | |
drive may have been damaged. |
| restart the computer. |
| 2. | Check the hard drive format using fdisk: If NTFS |
|
| formatting, use a third party reader to evaluate the drive. |
|
| If FAT32 formatting, the hard drive cannot be accessed. |
|
| |
System files missing or not properly installed. | 1. Insert a bootable diskette into the diskette drive and | |
|
| restart the computer. |
| 2. | Check the hard drive format using Fdisk: If NTFS |
|
| formatting, use a third party reader to evaluate the drive. |
|
| If FAT32 formatting, the hard drive cannot be accessed. |
| 3. | Install system files for the appropriate operating system. |
| 4. | Restore the system to a recovery point in HP Backup and |
|
| Recovery Manager. Refer to the HP Backup and |
|
| Recovery Manager User Guide in the Windows Start |
|
| menu for more information. |
|
| |
Hard drive boot has been disabled in Computer Setup. | Run the Computer Setup utility and enable the hard drive entry | |
| in the Storage > Boot Order list. | |
|
| |
Bootable hard drive is not attached as first in a | If attempting to boot from a hard drive, ensure it is attached to | |
configuration. | the system board connector labeled P60 SATA 0. | |
|
| |
Bootable hard drive's controller is not listed first in the Boot | Run the Computer Setup utility and select Storage > Boot | |
Order. | Order and ensure the bootable hard drive's controller is listed | |
| immediately under the Hard Drive entry. | |
|
|
|
Computer will not boot from hard drive. |
|
|
|
| |
Cause | Solution | |
|
| |
The device is attached to a SATA port that has been disabled | Run the Computer Setup utility and ensure the device's SATA | |
in Computer Setup. | port is enabled in Storage > Storage Options. | |
|
| |
Legacy operating system does not support boot devices | Connect boot devices to SATA 0 or SATA 1 ports. | |
attached to SATA 4 or SATA 5 ports. |
|
|
|
| |
Boot order is not correct. | Run the Computer Setup utility and change boot sequence | |
| in Storage > Boot Order. | |
|
| |
Hard Drive's "Emulation Type" is set to "None." | Run the Computer Setup utility and change the "Emulation | |
| Type" to "Hard Disk" in the device's details under Storage > | |
| Device Configuration. | |
|
| |
The device is attached to a SATA port that has been disabled | Run the Computer Setup utility and ensure the device's SATA | |
in Computer Setup. | port is enabled in Storage > Storage Options. | |
|
| |
Hard drive is damaged. | Observe if the front panel Power LED is blinking RED and if | |
| any beeps are heard. See Appendix A, POST Error | |
| Messages on page 49 to determine possible causes for the | |
| blinking red and beep codes. | |
See the Worldwide Limited Warranty for terms and conditions.
ENWW | Solving Hard Drive Problems 19 |