Solving Software Problems

Most software problems occur as a result of the following:

The application was not installed or configured correctly.

There is insufficient memory available to run the application.

There is a conflict between applications.

Be sure that all the needed device drivers have been installed.

If you have installed an operating system other than the factory-installed operating system, check to be sure it is supported on the system.

NOTE: HP Backup and Recovery Manager can be used to restore the software to a recovery point or to restore the system to its factory configuration. Refer to HP Backup and Recovery Manager

on page 6 for more information.

If you encounter software problems, see the applicable solutions listed in the following table.

Table 2-19Solving Software Problems

Computer will not continue and no HP logo screen has appeared.

Cause

Solution

 

 

POST error has occurred.

Observe the beeps and LED lights on the front of the computer.

 

See Appendix A, POST Error Messages on page 48 to

 

determine possible causes.

 

See the Restore Kit or the Worldwide Limited Warranty for

 

terms and conditions.

 

 

Computer will not continue after HP logo screen has appeared.

Cause

Solution

 

 

System files may be damaged.

Restore the files from the Recovery Disc Set or backups you created in HP Backup and Recovery Manager.

“Illegal Operation has Occurred” error message is displayed.

Cause

Solution

 

 

Software being used is not Microsoft-certified for your version

Verify that the software is certified by Microsoft for your version

of Windows.

of Windows (see program packaging for this information).

 

 

Configuration files are corrupt.

If possible, save all data, close all programs, and restart the

 

computer.

 

 

46 Chapter 2 Troubleshooting Without Diagnostics

ENWW