b.To insert the new battery, slide one edge of the replacement battery under the holder’s lip with the positive side up. Push the other edge down until the clamp snaps over the other edge of the battery (2).
Figure B-2 Removing and Replacing a Coin Cell Battery (Type 2)
Type 3
a.Pull back on the clip (1) that is holding the battery in place, and remove the battery (2).
b.Insert the new battery and position the clip back into place.
Figure B-3 Removing a Coin Cell Battery (Type 3)
NOTE After the battery has been replaced, use the following steps to complete this procedure.
9.Replace the access panel.
10.If the computer was on a stand, replace the stand.
11.Reconnect the power cord and turn on the computer.
ENWW | 33 |
