Network Problem Continued
Problem
Network controller stopped working when an expansion board was added to the computer.
Network controller stopped working without apparent cause.
Cannot connect to the network server when attempting Remote System Installation.
System Setup utility reports unprogrammed EPROM.
Possible Solution
1.Network drivers are not loaded or driver parameters do not match the current configuration. Make sure that the drivers are loaded and that the driver parameters match the configuration of the network controller.
2.The cable is not securely connected or is attached incorrectly. Ensure that the cable is securely attached to the network connector and that the other end of the cable is securely attached to the correct device.
3.Network controller interrupt with an expansion board. Under the Computer Setup Advanced menu, change the resource settings for the board.
4.Network drivers were accidentally deleted when the drivers for the new expansion board were installed, or the files containing the network drivers are corrupted. Reinstall the network drivers, using backup diskettes.
1.The files containing the network drivers are corrupted. Reinstall the network drivers, using backup diskettes.
2.The cable is not securely connected or is attached incorrectly. Ensure that the cable is securely attached to the network connector and that the other end of the cable is securely attached to the correct device.
3.The network controller is defective. Replace the network controller or system board.
The network controller is not configured properly. Run Computer Setup and modify the Embedded NIC Settings.
1.Boot the workstation without the network drivers using a system boot diskette and reconfigure the controller.
2.Replace the controller.
3.Replace the system board.
Further Troubleshooting |