HP G62-100 B5A24UA#ABA, G62-100 G62 manual Windows, Creating recovery discs

Windows 7

To protect your information, back up your files and folders. In case of system failure, use the backup files to restore the computer.

CAUTION: In the event of a hard drive failure, you cannot use the computer to access the Disaster Recovery utility. Therefore, HP recommends downloading the Disaster Recovery utility SoftPaq, and then extract it to a USB flash drive as soon as possible after software setup. For details, see “Downloading and extracting the Disaster Recovery utility” later in this section.

Depending on the computer model, you might have one of the following backup and recovery solutions:

●Roxio BackOnTrack

●HP Recovery Manager

NOTE: For detailed information, perform a search for these topics in Help and Support.

Creating recovery discs

HP recommends creating recovery discs to be sure that you can restore your system to its original factory state if you experience serious system failure or instability. Create these discs after setting up the computer for the first time.

Handle these discs carefully and keep them in a safe place. The software allows the creation of only one set of recovery discs.

NOTE: Use an optional external optical drive (purchased separately) to create recovery discs, or purchase recovery discs for the computer from the HP Web site.

Note the following guidelines before creating recovery discs:

NOTE: The external hard drive must be connected to a USB port on the computer, not to a USB port on an external device such as a hub.

●Use high-quality DVD-R, DVD+R, BD-R (writable Blu-ray), or CD-R discs. All these discs are purchased separately. DVDs and BDs have a much higher capacity than CDs. If you use CDs, up to 20 discs might be required, whereas only a few DVDs or BDs are required.

NOTE: Read-write discs, such as CD-RW, DVD±RW, double-layer DVD±RW, and BD-RE (rewritable Blu-ray) discs, are not compatible with the Recovery Manager software.

●The computer must be connected to AC power during this process.

●Only one set of recovery discs can be created per computer.

●Number each disc before inserting it into the optical drive.

●If necessary, exit the program before you have finished creating the recovery discs. The next time you open Recovery Manager, you are prompted to continue the disc creation process.

To create a set of recovery discs:

1.Select Start > All Programs > Recovery Manager > Recovery Disk Creation.

2.Follow the on-screen instructions.

Windows 7 101