3 Setting Up the Monitor

To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other attached devices, then follow the instructions below.

Installing the Monitor Pedestal Base

To install the monitor pedestal base:

1.Place the pedestal base on your desktop or table and check to be sure the arrow on the underside of the base is facing forward.

NOTE: Do not install the base if the monitor will be used on a wall, swing arm, or other mounting fixture; instead refer to Mounting the Monitor on page 8.

2.Using both hands, position the monitor over the pedestal base and press down firmly to lock the pedestal base in place. When the base locks, it will make a clicking sound. Make sure the pedestal base is securely locked before continuing with the setup.

Figure 3-1Inserting the Monitor into the Pedestal Base

Connecting the Monitor

1.Place the monitor in a convenient, well-ventilated location near the computer.

2.Connect the monitor signal cable on the back of the monitor to the video connector on the rear panel of the computer.

4 Chapter 3 Setting Up the Monitor

ENWW