2.Place the stand on a desktop or table and push the neck on the stand down to its lowest position. Slide the monitor all the way onto the stand so that the Quick Release mounting device emits an audible click and is locked in place.

Figure 3-2Installing the Monitor on the Stand

3.Route the monitor VGA and power cables through the cable guides at the bottom corners of the mounting panel (select models).

Figure 3-3Routing Monitor VGA and Power Cables

4.To install an HP USDT computer on the rear of the stand, follow the procedure in Installing an HP Ultra-slim Desktop (USDT) on the Stand on page 7. To install an HP Thin Client computer on the rear of the stand, follow the procedure in Installing an HP Thin Client on the Stand

on page 11.

6 Chapter 3 Setting Up the Monitor

ENWW