Removing the Monitor from the Stand
You can remove the monitor panel from the stand to mount the panel on a wall, a swing arm, or other mounting fixture.
CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the power and signal cables are both disconnected.
1.Disconnect and remove the signal and power cables from the back of the monitor.
2.Adjust the monitor height to its highest position.
3.Press the Quick Release lever all the way to the left or right (1) then slide the monitor up and off the stand (2).
Figure
Monitor Mounting Alternatives
The HP Quick Release can be removed from the monitor stand and installed on a mounting fixture. This allows you to quickly and securely mount the monitor panel onto a swing arm, wall, desk or other mounting fixture.
1.Remove the monitor panel from the stand. Refer to Removing the Monitor from the Stand on page 18.
2.Remove the HP Quick Release from the monitor stand by removing the four screws that secure the HP Quick Release to the stand.
3.Install the HP Quick Release onto the mounting fixture or wall then slide the monitor all the way down onto the HP Quick Release so that it clicks and locks in place.
CAUTION: The Quick Release is designed to support a maximum of up to 24 lbs. (10.9 kg). If you are mounting to a wall, HP recommends that you consult with a qualified engineering, architectural, or construction professional to determine the appropriate type and quantity of mounting fasteners required for the application and to ensure that the mounting solution is properly installed to support applied loads.
18 Chapter 3 Setting Up the Monitor | ENWW |