Face-up/face-down lever
1Remove all covers, the RFI shield, the printer door, the exit roller, the delivery assembly, the fuser pressure plate, the front casing, the heating element, and the pressure roller.
2Rotate the lever forward 90 degrees (past the spring) and pull it straight out the front of the printer.
To reinstall
1Make sure the lever arm is on the left and is initially pointing downward.
2Pull the spring forward using needlenose pliers.
3Slide the short, round tabs into the grooves on the separation guide assembly. The machined ridges on the lever will face you.
4Release the spring so it falls in place in front of the square tab.
| Figure 48. |
|
|
| |
Note | You can tell when the lever is in place because there are two plastic | |
| grooves that fit precisely in front of the exit rollers, and you should be | |
| able to feel the spring’s release mechanism. |
|
|
|
|
120 Removal and replacement | EN | |