HP Model Vehicle 6120 Figure 5-14.Assign Priorities to the Selected DSCPs, Figure 5-13.Display the Current Configuration in the DSCP Policy Table

Quality of Service (QoS): Managing Bandwidth More Effectively Using QoS Classifiers to Configure Quality of Service for Outbound Traffic

For example, suppose you wanted to assign this set of priorities:

Source-Port	DSCP	Priority
A2	000111	7
B1-B3	000101	5
B4, C2	000010	1

1.Determine whether the DSCPs already have priority assignments, which could indicate use by existing applications. This is not a problem as long as the configured priorities are acceptable for all applications using the same DSCP. (Refer to the “Notes on Changing a Priority Setting” on page 5-36.Also, a DSCP must have a priority configured before you can assign any QoS classifiers to use it.)

The DSCPs for this example have not yet been assigned an 802.1p priority level.

Figure 5-13. Display the Current Configuration in the DSCP Policy Table

2.Configure the priorities for the DSCPs you want to use.

Priorities Configured in this step.

Figure 5-14. Assign Priorities to the Selected DSCPs

5-31