QuickSpecs

HP rp5800 Retail System

Standard Features and Configurable Components (availability may vary by country)

DDR3 Synchronous DRAM NON-ECC System Memory

Memory upgrades are accomplished by adding single or multiple DIMMs of the same or varied sizes. This chart does not represent all possible memory configurations. The HP rp5800 Retail System supports non-ECC DDR3 PC3-12800 (1600 MHz) and PC3- 10600 (1333 MHz) memory.

CAUTION: You must shut down the Retail System and disconnect the power cord before adding or removing memory modules. Regardless of the power-on state, voltage is always supplied to the memory modules as long as the Retail System is plugged in to an active AC outlet. Adding or removing memory modules while voltage is present may cause irreparable damage to the memory modules or system board.

Memory Configurations:

Maximum Memory

Supports up to 16 GB of DDR3 SDRAM using DIMM modules. Slot 1 is black and must always

 

be populated. Not all memory configurations possible are represented below.

 

NOTE:

 

 

 

 

 

 

 

For systems configured with more than 3 GB of memory and a 32-bit operating system, all

 

memory may not be available due to system resource requirements. Addressing memory

 

above 4 GB requires a 64-bit operating system.

 

 

 

 

 

 

 

 

 

 

 

Total Memory

 

 

Slot

 

 

 

 

 

Channel A

 

 

Channel B

 

1 (black)

 

2 (white)

 

3 (white)

 

4 (white)

1 GB

1 GB

 

 

 

 

 

 

2 GB

1 GB

 

 

 

1 GB

 

 

(dual channel symmetric)

 

 

 

 

 

 

 

4 GB

1 GB

 

1 GB

 

1 GB

 

1 GB

(dual channel symmetric)

 

 

 

 

 

 

 

8 GB

2 GB

 

2 GB

 

2 GB

 

2 GB

(dual channel symmetric)

 

 

 

 

 

 

 

16 GB

4 GB

 

4 GB

 

4 GB

 

4 GB

(dual channel symmetric)

 

 

 

 

 

 

 

NOTE: The Intel Q67 Express chipset includes a built-in Management Engine (ME), which allocates memory for manageability functions. Management Engine memory is shared with system memory. If the POS System contains a single SO-DIMM, 16 MB of memory is pre-allocated for it at system startup. If the POS System contains two SO-DIMMs, 32 MB of memory is pre-allocated. This memory is not made available to the operating system, just as pre-allocated video memory is not available.

DA - 13982 North America — Version 12 — November 8, 2013

Page 7

Page 7
Image 7
HP rp5800 POS Terminal XZ956UT#ABA DDR3 Synchronous Dram NON-ECC System Memory, Memory Configurations, Maximum Memory