Dual-roll spindle
4.If you need to raise the carriage beam, go to the front panel and select the Substrate menu 
, then Substrate management, and press OK. Select Carriage beam position > Move to highest position. This process takes about 2 minutes to complete.
The printer raises the carriage beam, making it easy to insert the substrate. This process takes about 2 minutes to complete. During this period, you can load the input and output rolls.
NOTE: While the carriage beam is rising, you can stop it by pressing the Cancel key.
5.You may find it helpful to lock the differentials on the input and output spindles while loading.
6.Bring the new rolls on their spindle to the rear of the printer, with the geared end of the spindle on the left.
7.If the two rolls are of unequal lengths, the longer roll should be on the right as seen from the front of the printer; on the left as seen from the rear.
NOTE: When the shorter roll comes to an end, you should lock the differential hub if you intend to continue printing on the longer roll.
8.Rest the ends of the spindle on the platforms provided at the rear of the printer; plastic pads are provided to absorb the impacts.
6 Chapter 2 Use of the | ENWW |
