HP UX Diagnostics Software Creg, Displog, Exit, Starting Execution of Cpudiag Section END of Loop

CREG	--	Displays selected control and application registers
ODE Commands		Available from CPUDIAG

Basic Commands

--------------

HELP -- Prints detailed information to the screen, when

	"help	command" or	"help var" is typed
LS	--	List modules available on boot medium
Module_Name -- Load			and initialize a module by typing its name
		(For more		help, type "help module_name")
RUN -- Run a module			(after	setting desired environment variables)
Control-YControl-C			-- Abort an ODE command; pause a module run
RESUME -- Restart a			paused	module
DISPLOG		-- After running a		module, display contents of a log
EXIT --		Return to next higher level prompt

Environmental Variables

-----------------------

SHOWSTATE -- Display the value of the following environment variables: LOOP -- Run a test this many times

ERRPRINT [ONOFF] -- Print low-level error messages to console (primarily for manufacturing use)

ERRNUM [ONOFF] -- Print one-line, numbered errors to the console ERRPAUSE [ONOFF] -- Pause module upon error detection

ERRONLY [ONOFF] -- Print ONLY error messages; disable non-error and isolation message printing

INFOPRINT [ONOFF] -- Print informational messages to the console ISOPRINT [ONOFF] -- Print fault isolation messages to the

console

ISOPAUSE [ONOFF] -- Pause module when isolation message is generated

LOGSIZE -- Set the size of a message log

DEFAULT -- Reset environment variables to default state CPUDIAG> help section cr

SECTION {integer: 0..3 integer integer integer/integer [integer] [integer/integer] }. This command sets a 4 bit logical integer bit mask. Each bit corresponds to a test section in the diagnostic. For each bit that is set a test section is executed. Examples: SECTION 3 sets bit three and clears all other bits. SECTION 1 3 sets bits one and three and clears all other bits. SECTION 1/3 is equivalent to SECTION 1 2 3.

CPUDIAG> section 2

CPUDIAG> loop 2

CPUDIAG> run cr

STARTING EXECUTION OF CPUDIAG

SECTION 002

END OF LOOP 1.

STARTING EXECUTION OF CPUDIAG

SECTION 002

END OF LOOP 2.

RUN COMPLETED. CPUDIAG> exit ODE> exit fs0:\efi\diag>

Running ODE Tools on Integrity Systems and Itanium Worksations 21