Screws,

M2.5x4mm (2)

Screws,

M2.5x4mm (2)

Figure 2-5. Removing the Hard Disk Tray

Reassembly Notes

•Insert the connector end of the drive through the opening in the tray, then lower the drive into place.

•Carefully slide the hard drive assembly into its compartment. Press firmly to make sure the connector seats properly.

Important

If you are installing a new hard disk drive, install the factory software and operating system on the drive before loading any additional software—see “Recovering and Reinstalling Software,” below.

HP Pavilion zt1100/xz100 Omnibook xt1000

Removal and Replacement

2-7