1.Remove the following components from the old motherboard and install onto the new motherboard:

•CPU module

•Wireless LAN mini-PCI card (if present)

•SDRAM modules

2.Follow the reassembly notes in the section entitled “Removing the Motherboard” on page 2-50.

Note: After Replacing the Motherboard

If present, insert the modem port cover into the modem port opening. Afterwards, you must use the Service Utility floppy disk to store the system data and display information in the EEPROM on the new motherboard. To do so:

1.Plug in an AC adapter.

2.Insert the Service Utilities floppy disk in the floppy drive.

3.Turn on the notebook.

4.If you hear 5 beeps, press F1 to update the display data stored on the motherboard. Let the notebook reboot and go to the next step.

5.Select the Serial Number option from the boot menu.

6.If you successfully stored system data on the floppy disk before removing the old motherboard, type A for the automatic update. This restores the old system data on the new motherboard.

If you did not store system data, type M for the manual update option. Enter the serial number from the bottom of the notebook—you might have to contact an HP support center to do this.

2-58 Removal and Replacement

Service Manual