The following table lists POST messages and explanations for reported problems. If the system fails after you make changes in BIOS Setup, reset the notebook, enter BIOS Setup, and install the defaults or correct the error.

Table 3-5. POST Messages

MessageDescription

0200 Failure Fixed Disk

Fixed (hard) disk is not working or not configured properly. Make sure the hard disk is installed properly. Run BIOS Setup and make sure the hard disk type is correctly identified.

0210 Stuck key

Stuck key on keyboard.

0211 Keyboard error

Keyboard is not working.

0212 Keyboard Controller Failed

Keyboard controller failed the test. Might require replacing the motherboard (contains the keyboard controller).

0213 Keyboard locked – Unlock key switch

Unlock the system to proceed.

0220 Monitor type does not match CMOS – Run SETUP

Monitor type is not correctly identified in BIOS Setup.

0230 Shadow RAM Failed at offset: nnnn

Shadow RAM failed at offset nnnn of the 64k block at which the error was detected.

0231 System RAM Failed at offset: nnnn

System RAM failed at offset nnnn of the 64k block at which the error was detected.

0232 Extended RAM Failed at offset: nnnn

Extended memory is not working or not configured properly at offset nnnn. Update to the latest BIOS version.

0250 System battery is dead – Replace and run SETUP

CMOS clock battery indicator shows that the CMOS battery is dead. Connect the AC adapter for at least 24 hours, then run BIOS Setup to reconfigure the system.

0251 System CMOS checksum bad – Default configuration used

System CMOS has been corrupted or modified incorrectly, perhaps by an application that changes CMOS data. In response, the BIOS has installed the default Setup values. Use BIOS Setup to modify these values if needed. If the error persists, check the system battery. Connect the AC adapter for at least 24 hours; replace the motherboard.

0260 System timer error

Timer test failed. Replace the motherboard.

0270 Real time clock error

Real-time clock failed the BIOS test. Might require replacing the motherboard.

0271 Check date and time settings

BIOS found the date or time to be out of range, and reset the real-time clock. You might need to use BIOS Setup to reset the legal date.

0280 Previous boot incomplete – Default configuration used

Previous POST did not complete successfully. POST loads default values and offers to run BIOS Setup. If the failure was caused by incorrect values that are not corrected, the next boot will likely fail. This error is cleared the next time the system is booted.

0281 Memory Size found by POST differed from CMOS

Memory size found by POST differed from that specified in CMOS.

02B0 Diskette drive A error

Drive A: is present but fails the BIOS POST diskette tests. Make sure the drive is defined with the proper diskette type in BIOS Setup and that the drive is connected correctly.

02B2 Incorrect Drive A type – run SETUP

Type of floppy drive A: not correctly identified in BIOS Setup.

02D0 System cache error – Cache disabled

RAM cache failed and BIOS disabled the cache. May require replacing the motherboard.

A disabled cache slows system performance considerably.

02F0: CPU ID:

CPU socket number for Multi-Processor error.

02F4: EISA CMOS Not Writeable

ServerBIOS2 test error: Cannot write to EISA CMOS.

Service Manual

Troubleshooting and Diagnostics

3-23