![Operation](/images/new-backgrounds/112248/11224823x1.webp)
| Pub. |
Model | Page: 12 of 15 |
Operation
After installation, the Model
Installation and Maintenance
Direct questions about installation of this product to the
Installation Guidelines
WARNING
Disconnect power to the card rack before performing any maintenance.
Installation Instructions
1.Remove the VNA from its protective carton.
2.Verify that power is disconnected to the card rack prior to installation.
3.Verify that the switch and jumper settings described in the Switch and Jumper Settings section on page 4 are set in accordance with the instructions in your system manual.
4.Align the VNA into the upper and lower tracks for the card rack slot.
5.Slide the VNA toward the rear of the card rack until it comes in contact with the connector on the backplane.
6.Firmly press on the front bezel until the VNA is seated in the backplane connector, and tighten the two screws located on the front bezel to secure it to the card rack.
Removing the VNA Card from the Card Rack
1.Remove power from the card rack.
2.Remove the two screws on the front bezel that secures the VNA to the card rack.
3.Gently disengage the VNA from the connector on the backplane and slide the VNA out of the card rack.
\\s_eng\gtcproddocs\standard ioms - current release\42004 instr.