Hubbell LX3000 instruction manual Manual Start

No HIGH ENGINE	Water temperature	Connect a jumper	Replace water
TEMP indication	switch	across the water	temperature switch
		temperature switch on
		the engine
		Start engine with
		MANUAL START
		switch
		Verify that engine starts
		and alarm sounds
Engine overspeed does
not stop engine	Faulty or mis-adjusted	Check sensor	Replace sensor
No indication
	magnetic sensor	installation
	Main Logic Board		Replace Main Logic
Indication but engine	faulty		Board
does not stop under
overspeed simulation
Cranking and rest	Main Logic Board	Check Main Logic	Replace Main Logic
periods greater than or	faulty	Board	Board
less than 15 ± 2 sec.
Engine cranks less than
six times
Engine continues to
crank in AUTO
position but does not
start
Controller does not	Engine Relay Board	Check Engine Relay	Replace Engine Relay
crank engine with good	faulty	Board	Board
battery
Engine cranking and	Main Logic Board	Check Main Logic	Replace Main Logic
indication OK
	faulty	Board	Board