SECTION C: APPLY HEIGHT AND MOVING LABEL & SECURING SYSTEM
1. Carefully upright assembly. Apply moving system label (23) to front of pole as shown. Regulation
rim height is 10 feet (3.05 m). |
|
| ||
|
|
| WARNING! | |
|
|
| TWO PEOPLE REQUIRED FOR | |
|
|
| THIS PROCEDURE. FAILURE | |
|
|
| TO FOLLOW THIS WARNING | |
|
| 23 | COULD RESULT IN SERIOUS | |
|
| INJURY AND/OR PROPERTY | ||
|
|
| DAMAGE. | |
| HEIGHT ADJUSTMENT | WARNING! | ||
| TO ADJUST BACKBOARD: |
| ||
| 1. TO RAISE BACKBOARD: |
|
| |
| Slowly push up on the rim with broom | DO NOT LEAVE ASSEMBLY | ||
| handle or wooden dowel, |
| ||
| 3/4”- 7/8” (19mm - 22mm) diameter |
|
| |
| as shown to engage locking | LEVER | UNATTENDED WHEN EMPTY; IT | |
| mechanism at desired height. | 1 | ||
| 2. TO LOWER BACKBOARD: |
| MAY TIP OVER. | |
| Push lever up to unlock and | 2 | ||
| carefully lower backboard to lowest | BROOM | ||
10 ft. | position. | HANDLE | ||
MOVING SYSTEM | WARNING! | |||
(3.05 m) | ||||
1. | Adjust basketball backboard | |||
23 | 1 | height to lowest position. |
| |
2. | While holding pole, rotate | DO NOT ALLOW CHILDREN TO | ||
|
| until wheels engage with | ||
|
| basketball system forward |
| |
|
| ground. | ADJUST HEIGHT. | |
| 3. | Move basketball system to | ||
| 2 | desired location. |
| |
| 4. | Carefully rotate basketball | CAUTION! | |
| 3 | system upright. | ||
| 4 | |||
|
| |||
| 5. Reattach ground restraint and |
| ||
|
| check system for stability. |
| |
201257 3/99
ADD TWO GALLONS (7.6
LITERS) OF
ANTIFREEZE IN
NOTE:
NOTE:
Peel protective
film from surface
of acrylic
backboard prior
to use.
Sand | lb | . | kg) |
300 |
| ||
|
|
| |
(163 |
|
| |
IF USING SAND: 2 GALLONS OF
2. Place assembled unit in desired location. Fill tank with water (30 gallons/114 liters) or sand (300 lb./136 kg) and snap tank cap (4) in place.
4 
4
23 | 04/06 | ID# M7301241 |
