3.Use a
4.Locate the elevation reference edge on the elevation scale on the right side of the cap assembly. See Figures 14 and 15.
Elevation nut (one on each side)
Elevation reference edge
Figure 14: Locating the elevation reference edge
Read the elevation value at the elevation reference edge. In this picture, the elevation is set to 34°.
Figure 15: Reading the elevation reference edge
5.Move the canister until the elevation reference edge is at the correct value.
Later, when you point the antenna, you
6.When the edge is at the correct elevation value, tighten the two elevation nuts.
Chapter 3 • Installing the radio and antenna assemblies
17