The OPI attaches to the receive cable from the LNB, as shown in Figure 35. Note that the OPI will not work unless it is enabled on the appropriate screen on the installation software. (Check the box labeled Enable OPI Display.) For further details, see Outdoor
Pointing Interface Operating Instructions (HNS 1031832-0001).
DIRECWAY
OPI
LNB
(if rquired)
T0145011
IDU
Ground
block
Figure 35: OPI
OPI block If you use an OPI with a model
Female | Male | |
connector – | ||
connector – | ||
to cable | ||
to OPI | ||
|
Figure 36: OPI block
Install the block between the OPI and the radio as illustrated in Figure 35. Some variations of this block may have female
F connectors at both ends. If the block you use has two F connectors, you will have to make a jumper cable to connect to the OPI.
40
Chapter 5 • Pointing the antenna