To connect the feed arm to the antenna reflector:
1.Insert the
Make sure the hole in the wedge nut is aligned with the hole in the reflector so you can insert the bolt. See Figure 25.
Antenna reflector
|
| 5/16 - 18 | |
|
| wedge | |
|
| nut | |
Feed arm |
|
| |
|
| Wedge nut | |
Transmitter |
| ||
|
| ||
|
| flat washer | |
| 5/16 - 18 | ||
T0145009 | hex bolt | ||
lock washer | |||
|
Figure 25: Inserting the wedge nut bolt
2.Install the feed arm into the feed support socket on the underside of the antenna reflector.
If you have the reflector turned upside down to insert the feed arm, the orientation is the opposite of that shown in Figure 25.
3.Use a
Chapter 3 • Installing the radio and antenna assemblies
27