1. Select the L.O. Frequency that is set to antenna.
2. Use the buttons to select the LNB frequency (Universal,
5150, 9750, 10600, 10750, 11475MHz or 0, 1, ......., 9).
3. If the required LNB Frequency is not available, then select “0”
and enter the frequency manually using the
NUMERIC buttons(0~9).
4. When you select Universal, both 9750 and 10600MHz are
supported at the same time.
The 22KHz Tone setting is unnecessary. (Disabled)
When you use a dual LNB or two antennas connected
to a 22KHz Tone switch box, make 22KHz Tone switch enable or
disable to select LNB or antenna.
According to the option and position of DiSEqC switch,
select Disabled, Tone Burst Ato B and DiSEqC Ato D.
After setting the above mentioned value, press the OK button
to move to the Manual Search menu.
The Motorised System is used to set the DiSEqC 1.2 motor by
Eutelsat specification.
If you wish to use this system, please refer to page GB37.
LNB Frequency
22KHz Tone
DiSEqC Input
Motorised System
GB30