![](/images/new-backgrounds/1328772/32877237x1.webp)
531617-1_A - 1197c_ManE.qxp 11/6/2007 4:36 AM Page 11
7.Place the mounting bracket on the mounting surface aligned with the drilled holes and fill the mounting holes with marine grade silicone sealant. Insert the four #10
8.If the cable pass through hole is beneath the mounting bracket, you will need to install the hole cover after you have routed all cables. Place the hole cover over the mounting bracket cable pass thru hole and align with holes drilled in step 6a. Insert the #8 Phillips countersink wood screws. Hand tighten only.
NOTE: Be sure that the cables pass through the slots on the hole cover and that there is enough cable slack to allow for the control head to pivot through its full tilt range. Extra cable slack will also help when connecting or disconnecting the cables.
Cables Routed Directly Beneath Mounting Bracket
2
1 Gimbal Mounting Bracket
2 Hole Cover
1
Cables Routed Behind Mounting Bracket
1Gimbal Mounting Bracket
2Grommet
3Hole Cover
3 | 1 |
2
9. Thread the cables through the opening in the back of the cable collector cover.
11