4
Transducer Switch
4. Switching Transducers
Perform the following procedures to alternate between the transducers connected to your Transducer Switch.
To activate a transducer:
1.Press the Transducer Switch to select the desired transducer.
2.Turn on your control head.
3.In any view, press the MENU key twice to open the Main Menu.
4.Press the RIGHT or LEFT Cursor keys to highlight the Sonar menu tab.
5.Press the DOWN Cursor key to select Transducer Select.
6.Press the RIGHT or LEFT Cursor keys again to select a transducer.
5. Powering Off
It is important to make sure all accessories (switches, control heads, etc.) are powered off in order to avoid possibly draining the battery. To make sure your Transducer Switch is disengaged, follow the steps below.
If your Transducer Switch is connected to the fuse panel,
1. Power off your boat to disengage the switch.
If your Transducer Switch is connected to a battery switch,
1. Turn the dial of the battery switch to the OFF position.
If your Transducer Switch is connected directly to a battery,
1.Power off your boat.
2.Remove the Transducer Switch wires from the battery.
Changing Transducers in the Menu System
Sonar Menu
© 2011 Humminbird®, Eufaula AL, USA. All rights reserved.
