6.Insert cable connectors into the proper recesses on the cable collector insert. The cable connectors are keyed to prevent reverse installation, so be careful not to force the connectors into the wrong slots. If you don’t have a cable for every hole in the insert, install the blank plugs to protect the unit from the weather.
7.While holding cables in place in the cable collector insert, thread the cables through the slot in the bottom of the cable collector cover, line up the cable collector insert and cover, then slide the cover into place on the insert.
NOTE: Tab on cable collector insert goes into slot on cover.
8.Attach the cable collector insert to the cable collector cover using the 2 Phillip screws provided.
9.Plug the cable collector assembly into the back of the control head. Cable connectors and cable sockets are keyed to prevent reverse installation, so be careful not to force the connectors into the wrong sockets. Once the cable collector and all cables are plugged into the back of the control head, lock the assembly into place by threading the knurled screw into the threaded insert on the back of the housing. (Cable ties are provided to help you secure the cables in place by threading them through the available holes on the
NOTE: It is very important that the cable collector is used and secured in place in the
Plug Cable Connector Assembly to
Back of Control Head
1 2 3 4
1 Power
2 | Temperature | 5 |
|
|
3Communications
4Transducer
5Cable Collector Insert
2
1
4
5
3
1 Cable Collector Insert
2 Screws
3 Cable Collector Cover
4 Tab on Insert
5 Slot on Cover
9
