Alarm Tone, Setup Menu Tab | Humminbird 900 Series, 997c Combo

Alarm Tone

Alarm Tone selects the pitch of the alarm sound. A brief tone will be produced as you adjust the Alarm Tone so that you can select the tone that you can hear best.

To change the Alarm Tone setting:

1.Highlight Alarm Tone on the Alarms main menu.

2.Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Alarm Tone setting. (High, Medium, Low, Default = Medium)

Setup Menu Tab

From any view, press the MENU key twice to access the tabbed Main Menu System, then press the RIGHT cursor key until the Setup tab is selected.

NOTE: Menu choices will vary depending on system settings such as whether the unit is set for Advanced User mode and what accessories are attached to the control head.

Setup Menu

108

Image 115

Humminbird 900 Series, 997c Combo manual Alarm Tone, Setup Menu Tab

Contents

Page Thank You Table of Contents Menu System Start-Up Options Menu Sonar Menu Tab Setup Menu Tab Views Menu Tab How Sonar Works Series Introduction High Definition Side Imaging Sonar Peak to Peak measures power output at the highest points QuadraBeam Plus Sonar DualBeam Plus SonarOptional-purchase QuadraBeam Plus transducer only How GPS and Cartography Work Universal Sonar Multi-Media Card MMC/SD Slot Software Updates Installation Overview Accessory Bus900 Series has a wide variety of configurations Gimbal Mounting the Control Head Control Head InstallationBasic installation tasks that you must perform include Installing the GPS Receiver if includedPage Mounting Screws Cables Routed Behind Mounting Bracket Cables Routed Directly Beneath Mounting Bracket Back of Control Head Connecting the Control Head Power Cable to the Boat Transducer Position Transducer Installation Areas of Possible Turbulence Transom Transducer Installation To mount the transducer bracket to the boat Attaching the Bracket To attach the pivot to the transducer Normal Cavitation To mount the transducer pivot assembly to the bracket Tighten the Mounting Screws To route the transom transducer cable Trolling Motor Transducer Options Trolling Motor Transducer InstallationHole Escutcheon Plate Cable Clamp Hand-tighten only Test and Finish the Transducer Installation That hardware to mount the stem antenna pole GPS Receiver InstallationStem Mounting with an Existing 1 14 Thread Stem Follow these steps to stem mount the GPS receiver Access Under Mounting Location Access Under Mounting Location No Access Under Mounting LocationFinish Routing the Cable Check GPS Receiver Operation To test the installation Testing the System Installation Powering Up the Control Head Getting Started Using Your 900 Series Triplog What’s On the Sonar Display Real Time Sonar RTS Window Understanding Sonar History Sonar Bottom Presentation Understanding Side Imaging KHz provides highest resolution with 130 total beam widthKHz provides maximum coverage with 180 total beam width Triplog What’s on the Side Imaging Display Side Imaging On the water Interpretation Side Imaging Technology How it worksSide Imaging Representation Submerged Ravine with Timber Submerged Bridge a Closer Perspective Key Functions POWER/LIGHT KeySubmerged Barge with Dumped Logs Menu Key View Key WAY Cursor Control Key View Preset keysExit Key Goto Key has multiple functions, depending on the situation Info KeyMark Key Goto Key Views Zoom +/- Key Side Imaging View Views and ReadoutsSide Imaging View Sonar View Sonar View Sonar Zoom View Sonar Zoom View Split Sonar View Split Sonar View Side/Sonar Combo View Side/Sonar Combo View Snapshot and Recording View Page Recording Slider Bar Page Side Beam View Side Beam View, Default LayoutOnly with optional-purchase QuadraBeam Plus transducer Side Beam View, Slanted Layout Side Beam View, Classic Layout Bird’s Eye View Bird’s Eye View Chart/Bird’s Eye Combo View Chart/Bird’s Eye Combo View Chart/Chart Combo View Chart/Chart Combo View Chart View with Active Cursor Chart View Chart/Sonar Combo View Chart/Sonar Combo View Chart/Side Combo View Chart/Side Combo View Chart View with Cursor Present Chart OrientationViewing Cartography Navigation Waypoints, Routes and Tracks Save, Edit, or Delete a Waypoint Navigate to a Waypoint or Position Chart View with TargetAdd a Waypoint Target or Trolling Grid Save, Edit or Delete a Route Chart View with Grid Edit, Delete or Hide Saved Tracks Save or Clear a Current Track MOB Navigation Man Overboard MOB Navigation Press Menu Menu System Start-Up Options Menu Start-Up Options Menu Sonar Tab, Normal ModeNormal Simulator System Status System Status Exit Normal operation by powering your 900 Series offNormal Operation Simulator Self Test Screen Accessory TestAccessory Test Screen Self Test GPS Diagnostic View GPS Diagnostic View Active Side Sonar X-Press MenuSonar X-Press Menu Sensitivity Split Position Lower Range Upper Range Quad Layout Chart Speed Sonar Colors Cancel NavigationBottom Lock Bottom Range Side Imaging Views only Side Imaging X-Press MenuSide Imaging X-Press Menu SI Sensitivity SI SideSI Range Navigation X-Press Menu SI ColorsNavigation X-Press Menu Only with an active cursor on a waypoint Waypoint NameWaypoint Submenu Clear Current Track Chart or Combo view onlyCursor to Waypoint Save Current Track Save Current Route Cancel MOB NavigationSkip Next Waypoint Only if a Grid is active Remove TargetRemove Grid Only if a Target is active Snapshot and Recording View only Snapshot and Recording Press MenuSnapshot and Recording PressMenu To delete an image Start RecordingStop Recording Delete Image Delete Recording Delete All Images To specify the pings per second Delete All RecordingsPings Per Second Playback Speed Sonar Menu Tab Stop PlaybackSonar Menu Side Views only Beam SelectSide View Frequency Transducer will be displayed on the screen Transducer Cone and Fish Arches Fish ID+ RTS Window Wide Fish ID SensitivityRTS Window Narrow RTS Window Off Advanced, with optional purchase QuadraBeam Plus transducer Bottom ViewZoom Width KHz Sensitivity Depth Lines To change the 455 kHz Sensitivity settingDepth Lines Advanced Noise Filter Surface ClutterSurface Clutter Water Type Max Depth Color Bar Temperature GraphSonar View only, with Temperature input Transducer Select Current Track Submenu Navigation Menu TabCurrent Track Navigation Menu Saved Tracks Submenu Saved TracksWaypoints Waypoints Submenu contains the following menu choices Routes Submenu Routes Trolling Grid Rotation North ReferenceTrackpoint Interval Track Color Range Track Min DistanceMap Datum Export All Nav Data Continuous Navigation ModeCourse Projection Line Delete All Nav Data Chart Detail Level Chart Menu TabChart Menu Lat/Lon Grid Map BordersSpot Soundings Shaded Depth Navaids on Birds Eye ViewSet Simulation Position Clear Map Offset Set Map Offset Alarms Menu Alarms Menu TabDepth Alarm Fish ID Alarm Aux Temp Alarm Low Battery Alarm Off Course Alarm Temp AlarmOff Course Alarm Drift Alarm Arrival Alarm Setup Menu Tab Alarm ToneSetup Menu Units Speed Units DepthUnits Temp Units Distance Language User ModeTriplog Reset Restore Defaults Select Readouts Off Triplog Position Voltage Aux. TemperatureSpeed Customized Sonar View Default Sonar View Local Time Zone Aux Temp OffsetSpeed Calibration Temp Offset Date Format Daylight Saving TimePosition Format Time Format Nmea Output Digits Format Views Menu Tab SonarViews Menu Following views are available Using Screen Snapshot Accessories Menu Tab 119 Series Doesn’t Power Up Troubleshooting Control head loses power at high speeds Display Problems Finding the Cause of Noise Humminbird Service Policy Year Limited Warranty Returning Your Unit for Service Series include Series AccessoriesPage Operating Frequency SpecificationsPower Output Depth Capability Sonar Terms Glossary 129 Glossary Receiver See Transmitter Glossary 133 GPS & Navigation Terms Glossary Sonar Terms 135 Glossary Glossary Transducer Mounting Template XHS 9 Hdsi 180 T GlossaryGPS & Navigation Terms Appendix a Contact Humminbird