Attaching the Bracket

5.Align the metal mounting bracket with the mounting holes. The center slot should be above the two outer slots. (This bracket and all other hardware supplied is top quality stainless steel for maximum strength and corrosion protection.) Insert the three 1" (25 mm) flat head wood screws into the drilled holes, but do not completely tighten.

To attach the pivot to the transducer:

1.Attach the pivot to the transducer body, using the two 1/4"-20 x 5/8" (16 mm) machine screws, toothed washers, and square nuts. The toothed washers must fit on the inside of the transducer ears, between the pivot and the ears. The square nuts will be prevented from rotating by the pocket in the back of the pivot. An Allen wrench is provided which fits all the 1/4"-20 screws, but do not fully tighten the screws at this time.

 

 

3

1

2

4

 

 

 

1

Insert the square nuts

 

2

Toothed Washer

 

3

Pivot

Attach the Pivot

4Machine Screw

16

Page 23
Image 23
Humminbird 900 Series, 997c Combo manual To attach the pivot to the transducer, Attaching the Bracket