Step 6: Final Wiring
A. Connect electrical supply leads to the leads from motor, using approved connectors. Connect black electrical supply lead to the black motor lead and the black with white stripe motor lead (see Note). Connect the white electrical supply lead to the white motor lead. Connect the ground wire to the green leads from the motor and ceiling plate. See Figure 6.
LEAD WIRES
CANOPY
GROOVE IN BALL
PIPE NIPPLE
ROTATE BALL UNTIL GROOVE IN BALL
ENGAGES TAB IN CANOPY
CEILING PLATE
GREEN GROUND WIRE
FIGURE 6
NOTE: If a separate wall switch will be used to control a light- ing accessory, connect the black wire with white stripe to the wall switch lead. The wall switch must be acceptable for use as a
CAUTION: No bare wire or wire strands should be visible after making connections.
B. After making the wire connections, the wires should be spread apart with the white and green wires on one side of the outlet box, and the black and black/white wires on the other side of the box.
The splices should be turned upward and pushed carefully up into the outlet box.
Step 7: Finish Fan Assembly
A. The ceiling plate has (3) mounting screw holes located on the side. Install (2)
Remove the fan from the ceiling plate hook. Make sure not to break any wire connections. The canopy has (2) mating slots and (1) mating hole. See Figure 7.
CEILING PLATE
MOUNTING SCREWS
MOUNTING HOLE
CANOPY
MOUNTING SLOTS (2)
FIGURA 7
FIGURA 7A
B. Position (2) slots in canopy directly under and in line with
(2)mounting screws in ceiling plate. Lift fan until ceiling plate mounting screws are seated in bottom of slots in canopy. Rotate fan counterclockwise until both mounting screws drop into slot recesses. Tighten screws securely. Install third screw into mounting hole.
CAUTION: Failure to securely assembly the canopy screws could result in the fan falling.
NOTE: For the handing fan configuration, rotate fan until groove in ball is positioned over tab in canopy. Make certain groove and tab are engaged before running fan. See Figure 7A. Failure to do this could result in the fan falling.
Step 8: Fan Blade Assembly,
Installation, and Balancing
A. Attach wood blades to blade brackets using three screws for each blade. See Figure 8. If your blades have large holes you must first insert the rubber grommets into the holes. See Figure 8A.
NOTE: Grommets are usually assembled by hand. If you use a tool, make certain you do not damage the grommet or blade when inserting the grommets.
Next assemble the blade to the blade bracket. Make sure all screws are tight to prevent vibration or wobbling. A cavity in the styrofoam packaging has been provided to nest the parts in during assembly to assure correct alignment of parts.
Even when the screws are tight, the blades may seem to be loose. This is normal when using grommets and will not be a problem.
BLADE
GROMMET
FIGURE 8 | FIGURE 8A |
©1991 HUNTER FAN CO.™ |