®
STEP 8 - ATTACHING THE SWITCH HOUSING
The switch housing is made up of two sections: the upper switch hous- ing, and the lower switch housing.
ATTACHING THE UPPER SWITCH HOUSING
1.Partially install two
Switch | Housing |
Housing | Assembly |
Mounting | Screw |
Plate | Upper Plug |
| Connector |
Upper |
|
Switch |
|
Housing |
|
Figure 8a - Attaching Upper Switch Housing to Switch Housing Mounting Plate
2.Feed the upper plug connector through the center opening of the upper switch housing. See Figure 8a.
3.Align the keyhole slots in the up- per switch housing with the hous- ing assembly screws installed in
4.Turn the upper switch housing counterclockwise until the hous- ing assembly screws are firmly situated in the narrow end of the keyhole slots as shown in Figure 8b. Install the one remaining #6- 32 x 3/8" housing assembly screw into the third hole in the upper switch housing. Tighten all three screws firmly.
CAUTION
Make sure the upper switch hous- ing is securely attached to the switch housing mounting plate. Failure to properly attach and tighten all three housing assem- bly screws could result in the switch housing and light fixture falling.
Figure 8b - Mounting the Upper Switch Housing
41545-01 6/10/2002
18
