Hunter Fan 41545 operation manual Hanging the FAN, Canopy Tabs and Grooves in Hanger Ball

®

STEP 6 - HANGING THE FAN

Sub-steps 1 and 2 apply to Flush, Standard, and Angle mounting. Sub- step 3 applies to Standard and Angle mounting only.

1.Swing the fan up so as to align the canopy screw holes with the mounting holes on the ceiling plate. Refer to Figure 6a.

2.Install and tighten the two #10- 32 x 1/2" mounting screws.

3.For Standard and Angle Mounting only: In addition to sub-steps 1 and 2, lift the fan housing towards the ceiling and rotate the fan until each canopy tab engages a groove in the hanger ball as shown in Figure 6b.

Groove in

Hanger Ball

Groove in

Hanger

Ball

Canopy

Tab

Ceiling Plate

Canopy

Note: If the tabs are already en- gaged, do not rotate.

WARNING

Failure to complete sub-steps 1 through 3 could cause fan to fall. (Sub-step 3 not applicable for flush mounting.)

Figure 6b - Canopy Tabs and Grooves in Hanger Ball

Figure 6a - Attaching Canopy to		continued
Ceiling	Plate
41545-01	6/10/2002

15