Hunter Fan 41545 operation manual Problem Probable Cause

®

PROBLEM PROBABLE CAUSE SOLUTION

Noisy operation (continued).	4.	Using non-approved speed control.
	5.	Glass screwed loosely to fixture.

4.Change to approved speed control.

5.Hand-tighten the light fixture screws. Ensure that rubber noise isolators are installed.

6. Switch housing is loose.

6.Check and tighten screws to the switch housing mounting plate and to the upper and lower switch housing.

Excessive wobbling.

Note: When switching from medium to low speed, you may notice some fan wobble. When the fan stabilizes at low speed, wobble will disappear.

1.Unbalanced blades.

2.Loose blades or blade irons.

3.Fan not secure on hanger assem- bly.

4.Fan hanger ball not seated in canopy tabs.

1.Use balancing kit included with fan.

2.Tighten all screws.

3.Turn power off, support fan very carefully, loosen canopy and hang correctly.

4.Turn power off, support the fan very carefully, and check that the hanger ball is properly seated.

If you have tried these troubleshooting solutions and still have trouble, call 901-248-2222 or visit our Web site at http://www.hunterfan.com.

41545-01 6/10/2002

25