Hunter Fan 41895-01 manual Installing the Canopy and Canopy Trim Ring

7 • Installing the Canopy and Canopy Trim Ring

Step 7-2 Ceiling Plate

Canopy	Canopy Trim
	Ring

10

Step 7-3

Steps 7-4 – 7-5

7-1. Holding the canopy, raise the fan off the hook.

7-2. Align the slots in the canopy with the tabs on the ceiling plate.

7-3. Raise the canopy over the ceiling plate. Rotate the canopy clockwise until the tabs on the ceiling plate totally engage with the slots in the canopy.

WARNING: When raising the canopy, make sure the antenna from the receiver is not pinched between the canopy and ceiling plate.

7-4. Partially install the three canopy screws into the canopy one at a time. Once all three screws are in, tighten them securely.

7-5. Using both hands, push the canopy trim ring up to the top of the canopy. e canopy trim ring will snap and lock into place.

Should you need to remove the canopy trim ring, follow these steps:

1.Locate the small bumps on top of the tabs.

2.Press firmly on opposite sides of the ring towards the canopy. e tabs will flex out releasing the trim ring from the canopy.

Canopy Screw

Hunter Fan Company 41895-01 • 10/14/05