8-1. To attach the light fixture, partially install two #6-32 x 3/8” assembly screws.
8-2. Connect the 9-pin plug from the fan housing to the connector from the light kit.
8-3. Place the keyhole slots in the light fixture over the partially installed screws.
8-4. Turn the light fixture counterclockwise until the assembly screws are firmly situated in the narrow end of the keyhole slots.
8-5. Install the remaining #6-32 x 3/8” screw into the light fixture. Tighten all three screws firmly.
CAUTION: Make sure the light fixture is securely attached. Failure to properly attach and tighten all three assembly screws could result in the light fixture falling.
8-6. read the pull chains through the metal disk at the bottom of the light kit.
8-7. Install three candelabra bulbs (40 Watts maximum each).
8-8. read pull chains through the hole in the center of the glass bowl and the center of the lower twig.
8-9. read the pull chains through the holes in the cover plate.
8-10. Install the finial to secure the cover plate, twigs, and bowl.
Twig
Cover Plate
