Read This Before Installing Thermostat

5

IMPORTANT

1Read the entire installation section of this Owner’s Manual thoroughly before you begin

to install or operate your Climate Technology Ther- mostat.

INSTALLATION

2All installation is normally performed at your thermostat.

ARMCHAIR PROGRAMMING

3You can program your thermostat before installation by inserting the batteries and following

the instructions starting on page 16. This can be done while you relax in your favorite chair and is a very good way to familiarize yourself with all the functions of your Climate Technology Thermostat.

OPERATION

4Your Thermostat is designed to operate with most gas, oil, electric or 2-wire hot water heating

and air conditioning systems. It will also operate single-stage heat pumps that do not have auxiliary or emergency heat. These have 24-volt or millivolt control systems and represent most central heating, air conditioning, or space heating units in use in the United States.

This Climate Technology Thermostat will NOT control multi-stage heat pumps or 110/220 Volt systems.

COMPRESSOR PROTECTION

5The thermostat provides a 3.5 minute delay after shutting off the heating or cooling system before it can be restarted. This feature will prevent damage

to your compressor caused by rapid cycling. Note that this delay also applies to the heating system control. It does not prevent a rapid compressor restart due to short power outages.

TEMPERATURE RANGE

6Your thermostat can be programmed between 45°F and 95°F (4°C and 35°C). However, it will display room temperatures from 32°F to 99°F (0°C

and 37°C). “HI” will be displayed if the temperature is higher than 99°F (37°C), and “LO” will be displayed if the temperature is lower than 32°F (0°C).

This thermostat will automatically cut off in Heat mode if the temperature rises above 95°F (35°C), and automatically cut off in cool mode if the temperature drops below 45°F (7°C).