Operation, Maintenance, & Cleaning
www.HunterFan.com
1.888.830.1326
Battery
Door
Phillips
Head
Screw
To access the battery compartment, remove the small Phillips head screw that secures the battery door to the transmitter assembly. The battery should be installed with the positive
(+)side up. Replace with a CR2032 battery when necessary.
High |
Fan Off |
Note: The remote must be paired
before the fan will operate.
Within 3 minutes of restoring power
to the fan, press both the Fan Off button and the High button for at least 4 seconds. Your fan will turn on low to indicate successful syncing. If it does not, turn off power to your
High
Medium
Low
Fan Off
The Fan Off button only turns the fan off. To turn the fan on, press one of the fan speed buttons.
oooHigh
oo Medium o Low
To install the transmitter cradle, remove the two screws holding your switch cover plate. Do not remove the cover plate. Orient the cradle by lining up the two
mounting holes with those on the cover plate. Insert and tighten the screws. Do not over tighten.
Turn Power |
ON |
fan, wait 1 minute then try again. If using the transmitter with multiple fans, repeat this process for each fan.
15
If you are installing multiple
