B20 | F |
| |
| 2 |
| 1 |
| F |
Install the wiring cover plate. Make sure all wiring connections are inside the box or under the wiring cover plate.
B21 |
2 |
G |
Tighten the wiring cover plate screw.
B26 |
Turn on the power source.
B27
ON
OFF
Test the motor. If the motor does not run, check the plug
connection.
B22 B23
B28
Go to step
E1
| H |
Connect 4” duct and vent to the outside. Tape joints. | Connect wiring from the motor to the wiring cover plate. |
If ducting does not fit securely, an adapter may need |
|
to be purchased. |
|
B24 B25
on page 18
to attach grille.
Existing Construction – accessible from above |
| |
C11 | EXISTING FAN | NO EXISTING FAN |
OR
H
Reinstall the motor by inserting the tabs and pushing up
into position. Make sure the wires are not pinched
between the motor and the housing.
10
I
Secure the motor by tightening the 2 screws.
Remove an existing fan and check to make sure the | Use the motor housing as a template to mark position. |
opening is large enough to accommodate the new |
|
motor housing (9”x 9.75”). |
|
11 |