C22 |
|
|
| Ground |
|
|
| Black |
| Green |
|
| 2 Pin |
|
| A | Bare Copper |
|
| White |
| ||
|
|
|
| ||
Fan Motor |
|
|
| Black | Main Switch 1 (AC In) |
Night Light |
| White |
|
| White |
| Red Night Light |
|
| ||
| 3 Pin |
|
| ||
Light | Black | Light |
|
| |
| Red | Switch 1 (AC In) | |||
|
| *Option | |||
|
|
|
| ||
*Option Fan & Main Light Together | Black | Switch 2 (AC In) | |||
|
| ||||
Connect wires as shown.
C27 | C28 |
I |
|
Secure the motor by tightening the 2 screws. | Turn on the power source. |
C23 | F |
| |
| 2 |
C24 
2
G
C29
ON
C30
Go to step
E1
1
F
Install the wiring cover plate. Make sure all wiring connections are inside the box or under the wiring cover plate.
Tighten the wiring cover plate screw.
OFF
Test the motor. If the motor does not run, check the plug
connection.
on page 18 to attach grille.
Existing Construction – accessible only from below
C25 
C26
D11 | EXISTING FAN |
D12 
E
H
Connect wiring from the motor to the wiring cover plate.
14
H
Reinstall the motor by inserting the tabs and pushing up
into position. Make sure the wires are not pinched
between the motor and the housing.
Remove an existing fan and check to make sure the open- | Move the housing into position above the ceiling. |
ing is large enough to accommodate the new motor hous- |
|
ing (9”x 9.75”). |
|
15 |
