Assembly continued
ENGLISH
5.With the Cast Iron Base rest- ing on the floor, place the Base Cover over the Cast Iron Base. See Figure 5.
Telescoping Pole
Cover Support Cap
Base Cover
Pole Setscrew
Cast
Iron
Base
FigURe 5
6.Slide the Cover Support Cap over the bottom of the Tele- scoping Pole.
7.Remove the Pole Setscrew (pre- installed, tagged). Place the bottom of the Telescoping Pole into the Cast Iron Base, making sure the plug connector from the bottom of the Telescoping Pole goes through the Cast Iron Base. Twist the Telescoping Pole clockwise to secure it into the Cast Iron Base.
8.Carefully raise the Cover Sup- port Cap and the Base Cover so as not to scratch the surface of the Telescoping Pole, and locate the Pole Setscrew
9.Use an adjustable wrench to tighten the Pole Setscrew (pre- inserted, tagged) until it stops firmly against the Telescoping Pole. See Figure 5.
10. Lower the Base Cover over the Cast Iron Base.
11. Twist the Cover Support Cap clockwise into the Cast Iron Base until it is tight.
12. Carefully lean the entire assembly over so that it rests on its side on the floor.
13. Remove one of the four Cover Assembly Screws from the bottom of the Cast Iron Base and loosen the three remaining Cover Assembly Screws. See Figure 6.
14.Connect the plugs coming from the bottom of the Telescoping Pole and the inside of the Elec- trical Cover.
15. Place the Electrical Cover against the bottom of the Cast Iron Base and align the Keyslots in the Electrical Cover with the three loosened Cover Assembly Screws. Rotate the Electrical Cover counterclockwise. See Figure 6.