2. Press the Mode button until the word “Max Station” appears
on the display. The maximum number of stations will be .
blinking at this point.
3. Use the 
or 
button to increase or decrease the
maximum number of stations. Then do not touch any of the buttons for 5 seconds and the display will stop blinking and return back to the active station.
The ICR is designed to operate with two groups of Hunter controllers:
SRC/Pro-C/ICC Controllers
The maximum number of stations from 1 to 48. The ICR also
provides the user with the ability to operate programs . (A, B, C).
ACC/ACC Decoder Controllers
Selecting the maximum station number 240 allows the user to operate up to 240 stations and 18 programs (programs are displayed with a P and program number ex: P5).
NOTE: When the ICR transmitter is set in the ACC mode (240 stations), the ICR will only communicate with ACC controllers. To operate other Hunter controllers (SRC,
Preparing the Receiver for Use............................................................
As stated earlier, your ICR is designed to work right out of the box. If you have decided to change your Transmitter address as described in the previous section, you must allow the Receiver to “learn” this new address. Once learned, the only way to remove the address from the Receiver memory is to learn a different address. This can be done by following the simple steps outlined below.
Changing the Receiver Address
1.Hold down the single button on the face of the Receiver while you are plugging it into an active
SmartPort® wiring harness (one connected to a powered controller). When this is done the . Receiver will beep 4 times.
