SmartPort® Wiring Harness........................................................................

To utilize the ICR remote control system, your controller must be equipped with a SmartPort wiring harness. This wiring harness provides the communication port where the ICR receiver is attached. The SmartPort can be connected to Hunter SRC, Pro-C and ICC controllers. A SmartPort wiring harness is provided with your ICR remote system. The typical SmartPort location is approximately 12" below the controller. The recommended installation procedure for this location would be as follows:

To Controller

 

1/2" Thread

 

Pre-assembled

Assembled

Installing the SmartPort Wiring Harness.........................................

1.Install a ½" female threaded “Tee” in the field wiring conduit approximately 12" below the controller.

NOTE: The harness may be installed outdoors by bringing the conduit through an exterior wall, then installing the appropriate fitting.

2.Feed the red, white, and blue wires of the SmartPort through the base of the “Tee” and into the controller wiring compartment as shown in the following figures..

NOTE: For installations where the receiver will be installed permanently on an outside wall, make certain that the SmartPort is the version with an o-ring seal.



Page 8
Image 8
Hunter Fan ICR owner manual Installing the SmartPort Wiring Harness