2.After the Receiver starts to beep, release the button.
3.Press either the “ON” or “OFF” button on your transmit- ter.
4.The Receiver will beep 4 additional times indicating that it has learned the new Transmitter address and will respond only to it from this point on.
The ICR system will allow you to remotely turn on and off any station on your Hunter controller with the press of a button. Once on, the station will run for the run time you have designated in the ICR transmitter.
Activating a Station with the ICR Remote System.......................
To remotely activate a station or program:
1.Plug your Receiver into an active SmartPort® wiring harness (one attached to a powered controller) and wait for 2 beeps indicating the Receiver is ready.
2.If your Transmitter is not on (no display), press any button for at least 1 second and release. The Transmitter will display the active station.
3.Use the 
or 
buttons to display the station or program (A,B, or C) you would
like to start.
4. Momentarily press the “ON” |
|
button to start the station or |
|
program. The Transmitter will | 45"5*0/ |
display the word “TRANSMIT” |
|
and will flash for about 4 seconds indicating that it is sending the command to the Receiver. If you are near the Receiver, you will hear it beep 2 times, indicating that it has received the command.
5.Press the “OFF” button at any time to turn off the station or program. The display will again read “TRANSMIT” and flash, and the Receiver will again beep twice. The ICR
is designed to turn one station on at a time. Therefore, turning a station on while another is already on will cause the first station to turn off.
6.If one of the programs (A,B, C or P1 through P18) is selected, all stations in the selected program will run sequentially for the run time programmed in the controller.
10
